Home > Support > Instructions

Instructions

  • 1 If silicon materials, which contain low molecular silicon compounds, adhere to the motor’s commutator, brush or other parts, then upon rectification of the electric energy the silicon breaks down into SiO2, SiC and other constituents which produce a rapid increase in the contact resistance between the commutator and brush. Therefore great care should be taken when silicon material is used in a unit and check well at the same time that such binding agents or sealing materials are not generating gases of detrimental nature, whether used for motor mounting or applied during your product assemblies.
    Care must be taken for an optimum selection, especially when using those of cyanic adhesive and sulfur gas.
  • 2 When mounting your motors by meams of binding agents,DON’T allow any adherence to the bearings nor intrusion into the motors.
  • 3 Axial thrust on the out put shaft could have an adverse effect on the motor life.i. e. As is produced by worm gears, fans, etc.,
    Check the service life expected under the actual operating conditions by testing the motors installed in your application products. For heavy thrust loads, consider using something mechanical to retain the shaft end.
  • 4 There are occasions when the internal resistance of the motor driving power source (Which contains an electrical circuit) can influence the life span of the motor.
    In instances where there is a low input of voltage to the motor, the internal resistance of the power source is large which may well result in an inferior motor after a short time, conversely in instances where high cyclic voltages are applied, this internal resistance is small and the motor life span is shortered. When the temperature deviates from the normal room temperature as is the case in low and high temperature situations, please note the conditions.
  • 5 Motor life may be affected adversely by heavy radial load such as produced by rotating eccentric cams, etc., and also by vibration given from outside
    DO check over such negative factors by testing the motors to the actual operating conditions in your application products.
  • 6 If when mounting motor and assembling the unit, equipment which emits ultrasonic waves is used there is a danger , that some of the internal parts of the motor might be damaged so please take care.
  • 7 7) DON’T store motors under environmental conditions of high temperature and extreme humidity . DON’T keep them also in an atomosphere where corrosive gas may be present, as it may result in malfunction.
  • 8 Ambient and operating temperatures exert an affect more or less on motor performance and life. DO pay partictular attention to the surroundings when it is hot and damp.
  • 9 When press fitting a pulley, gear etc., onto the motor output shaft, always support the shaft at the other end or its retaining metal pad in a proper and correct way.
  • 10 When soldering, BE SURE to finish your work quickly so as not to develop plastic deformantion around the motor terminals nor to give them any forced bend or inward depression.In doing so, special care must be taken not to allow solder debris and flux to spatter into motors and precautionary measures should be taken if neccessary, by covering up all the nearby holes and apertures. Any motors having snap in terminals must also be attended carefully so as not to get flux in along the terminals, as it may cause failure in electrical conduction.
  • 11 DON’T leave motor shaft locked while power is applied, as even a short-time lock-up may cause excessing heat build up resulting in burning damage to the motor dependeing on its specifications.
TOP